Bongo Description by SMcG
I had a tube of hundred millimetres in width and the lenght was three hundred & fifty        
millimetres. Then I measured halfway along the tube length side and marked it. 
Secondly I guessed a tiny bit extra off the line to have one part bigger than other. 
Thirdly I hacked it along the guesstimated line into two pierces. Fourthly I filed each top 
part of the separations until both of them were smooth. Fifthly I measured halfway
along the big one and marked it. Sixthly I used the mark as a measurement for the other one.
Seventhly I drilled a hole in each one where the marks use to be so I can the join the parts
together. Eighthly I fitted and screwed the joint so the two separations would be joined 
together with a gap between them. Penultimately I used no more nail to glue the canvases on 
to each top part of the pierces. Finally I used twine to tie down the canvas on each one to 
cover the top part sides. In the future I will paint a design of a skull on each one,
for the time been I will leave them the way they are.